Important: If the programming procedure does not finish successfully and the RCDLR appears to be in a "locked up" state do not turn off the ignition, follow the directions below. When programming, it is required to select "Replace and Reprogram ECU". Program the RCDLR with revised software using TIS-2-WEB "Pass Through" method. One of the fuses is labeled RDO/S'BAND/VICS and the other is labeled HVAC/PWR SND. The radio and HVAC fuses can be located in the BCM fuse block on the passengers floor electrical center. Important: Prior to programming per the information below, the Radio and HVAC Fuses MUST be removed and the ignition must be in "Key On Engine Off Mode" This could affect all vehicles built prior to October 2007. The new software will add a new zone to better cover the driver's seat, and it will also add a 2 second delay after the door closes before checking for the fob on the interior. This is because the original RCDLR software does not adequately cover the driver's seat and it can also detect the fob when it is slightly outside of the driver's door. They also may comment that the fob reminder (3 horn honks) is heard when exiting the vehicle with the key fob. Some customers may comment of an occasional "No Fob Detected" message displayed on the DIC when the fob is located somewhere on the driver's seat. The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI. This PI was superseded to add revised procedures that will recover the RCDLR when/if the RCDLR "Locks Up".
Subject: Occasional No Fob Detected Message On DIC Or Key In Reminder When Key Fob Outside Of Vehicle - keywords chime chirp horn no program RCDLR RKE transmitter #PIC4642A - ( )
0 kommentar(er)
